JMac - MDi-co

360 AUG 13x1LH KeyMount (KeyMicro)

No reviews. Leave a review
$114.95 $71.89
You save $43.06
Current Stock:
25
SKU:
RRD-360-13LS-KM
Weight:
3.46 Ounces
Shim Kit
Pin for Pin/Weld

(R)ecoil (R)eduction (360)Degree Ports (13L)13x1L (S)houlderMount (KM)KeyMount

The RRD-360 Muzzle Device from JMAC Customs is unlike others on the market today. This device vents gasses 360 degrees away from your muzzle requiring less effort from the shooter to manage recoil. The use of additional, smaller ports, allows the gasses to disperse in a less concentrated pattern which reduces flash and concussion when compared to a standard muzzle brake. Due to the 360 design, this device does not require timing which makes installation much more simple and does not require shims or crush washer. 

What makes the 360 unique?

  • 3 layers of protection for your suppressor
  • No timing / shims not required
  • Lightweight
  • Minimal added length
  • Compatible with dozens of suppressors
  • Reduced Recoil

 Specifications

  • 13x1LH Barrel Threads
  • 2.050" long (adds approx 1.45")
  • 10mm Bore
  • KeyMount and KeyMicro Compatible
  • 17-4ph Stainless
  • Black Nitride
  • *Not intended or recommend for barrels shorter than 10.5” (see below) 

*When testing these devices, we found that high rates of fire such as full auto or “mag dumps” could cause damage to the device due to the excess heat, pressure, and gasses from unburnt powder on shorter barrels.

 

 

 

 

*MAKE SURE YOUR AUG HAS LEFT HAND THREADS BEFORE ORDERING, MOST NEW AUG RIFLES HAVE 1/2-28 THREADS

Keymount Suppressor Compatibility

***JMac Customs is NOT responsible for improper installation of this muzzle device or any damage to the suppressor using this device. We recommend this be professionally installed and checked to ensure alignment.***

JMac Customs recommends that all suppressor mounts be installed and checked for alignment by a certified professional. Serious damage could result to your suppressor/firearm and physical harm is possible if installed/used incorrectly. All suppressor mounts MUST be tight against the shoulder or face of the barrel, using shims or face-milling method. Contact us if you have any questions or need a recommendation for professional installation. JMac Customs LLC is not liable for injury, damage, or death related to the usage of this product.

This is a licensed product through Dead Air Silencers. 

No one has reviewed this product! Write a Review

Related products